Owner's Manual

Unit Monitors
The following table provides information for the various Dell unit monitors and the applicable parameters for client
systems.
Table 6. Dell Unit Monitors In The Dell Client Management Pack
Groups Unit Monitor Name Default Periodic Poll Setting
OMCI Service Instance Periodic 3600 seconds
(60 minutes)
Memory Group for Dell Client Periodic 3600 seconds
(60 minutes)
Processor Group for Dell Client Periodic 3600 seconds
(60 minutes)
Processor Unit Instance Periodic 3600 seconds
(60 minutes)
Sensors of Dell client systems
• Battery
• Fan
• Intrusion
• Temperature
Periodic 3600 seconds
(60 minutes)
Storage Group for Dell Client Periodic 3600 seconds
(60 minutes)
Disk Unit Instance Periodic 3600 seconds
(60 minutes)
NOTE: When chassis door is removed or closed, OMCI generates Chassis Intrusion events. For more information
on enabling, disabling, and clearing Chassis Intrusion events, see System Setup (BIOS) in the Owner's Manual of
the Dell client system.
NOTE: Monitoring for memory is available at the Group level only.
Customizing Unit Monitors
You can customize the following parameters of the Dell Client Management Pack unit monitors by using overrides:
• Enabled — Allows you to enable or disable Monitors. You can set the Override setting to True or False. The
default setting is True.
• Interval in Seconds — The frequency in seconds with which the Dell Management Pack polls the Dell device to
check the health of a component. The default is 3600 seconds (60 minutes).
The unit monitors are triggered by a periodic poll configured as interval seconds.
17