User's Manual

22 Dell™ Client Management Pack Operations
State Components and Severity Levels
Tasks
Tasks are available in the Actions pane of the Operations Console. When you
select a device or a component in any of the Dell diagram views, the relevant
tasks appear in the Actions pane.
NOTE: You can run the tasks from the Diagram View, State View, or Alert View.
Dell Client Tasks
Client Reboot and Shutdown
You can use this task to reboot or shutdown any client. There are two ways
you can perform this task:
1
In the Operations Console, navigate to either the State View or Diagram
View
.
2 Select any discovered client. In the Actions pane, click either Client
Reboot or Client Shutdown.
The Run Tasks dialog is displayed. Click Run .
Table 3-1. Severity Level Indicators
Icon Severity Level
Normal/OK. The component is working as expected.
Warning/Noncri tical. A probe or other monitoring device has detected
a reading for the component that is above or below the acceptable level.
The component may still be functioning, but it could fail.
The component may also be functioning in an impaired state.
Critical/Failure/Error.The component has either failed or failure is
imminent. The component requires immediate attention and may need
to be replaced. Data loss may have occurred.
The health status is not applicable for the specific component.
The service is unavailable.
A5_bk0.book Page 22 Thursday, October 22, 2009 4:54 PM