Owner's Manual

file:///T|/htdocs/SOFTWARE/smconect/msscom/40ClientMP/en/readme/DellMPv40_Client_Readme.txt[10/19/2012 1:01:30 PM]
- Windows Vista Ultimate SP0
- Windows Vista Ultimate SP0 x64 Edition
- Windows Vista Ultimate SP1
- Windows Vista Ultimate SP1 x64 Edition
- Windows Vista Business SP1
- Windows Vista Business SP1 x64 Edition
- Windows Vista Enterprise SP1
- Windows Vista Enterprise SP1 x64 Edition
- Windows XP Tablet PC Edition
- Windows 2000 Professional SP4
- Windows 7 Professional x86 (32-bit) Edition
- Windows 7 Professional x64 (64-bit) Edition
- Windows 7 Ultimate x86 (32-bit) Edition
- Windows 7 Ultimate x64 (64-bit) Edition
#####################################################################
KNOWN ISSUES
#####################################################################
* After you remove the management pack, close and re-open the SCOM
console for a complete cleanup of cache. (DF310069)
* The description under the Management Pack Properties tab contains
unknown characters as separators. (DF325583)
* Improper display of the "Operating System" attribute in the SCOM
Detailed view is a limitation of the SCOM user interface - The
superscript symbols cannot be displayed in the SCOM attribute view.
(DF337447)
* Alert creation time is displayed differently in the Alerts view
and Windows Event Log report – The timestamp of alerts display a
variation in the Alerts view of SCOM and the Windows Event Log
report. The hours and minutes value of the timestamp match in both
the Alerts view and Windows event log report, but there is a slight
mismatch in the seconds value. (DF342957)
* The tooltip for objects in the Diagram view of the SCOM Web
console does not display any information related to attributes.
This is a limitation in the SCOM Web console. (DF342929)
* The Display Name attribute for Dell Client system is not displayed
in the SCOM Operations Console. (DF340250)
* Health status does not change to normal after the managed system recovers
from the Fan Probe - The Error-Health status of the sensor component does
not reflect the exact status of the Fan probe sensor upon recovering from
the Fan probe error.The correct health status of the Fan probe is shown only
after a system reboot. (DF342472)
* Status inconsistency among client diagram, complete Diagram and State
View - The state rollup is not immediate in SCOM. When a leaf node
changes its state, the change is reflected in the higher nodes after a time
interval. If you refresh the SCOM console, the proper health status is