Users Guide

42 Intel vPro OOB Management Extensions
NOTE: If your client systems are not connected to the network, you have to
run the task again.
•Run At — the package is queued in the Task Que ue .
NOTE: You can launch the Task Queue to view the list of completed and
pending tasks.
Configuring the Boot Order
Change or configure the boot order on the targeted client-systems.
1
Launch the AMT plug-in. For more information, see Launching the AMT
Plug-in.
2 On the DCIP’s Home screen, click Client Configuration .
3 On the Client Configuration window, click Boot Order .
The
Boot Order tab is displayed.
4 The table on the left side lists all the possible Boot devices. Change the
boot order by:
• Moving the boot devices up or down the order by clicking on the
Up
or
Down arrows at the bottom of the table.
• Disabling boot devices by clicking on the on/off toggle switch.
5 Select one of the configuration options:
•
One-time configuration — the boot-order will be changed for only
one reboot cycle.
•
Permanent configuration — the boot-order is permanently changed.
6 If you want the Task execution to continue to subsequent clients systems
when an error occurs, select the
Continue on error check box. Otherwise,
Task execution will stop on the first client system where an error is
encountered.
NOTE: The Re-Run task feature will allow you to pick up processing a Task
that is partially complete.
7 If you want to reboot the client systems after applying changes select the
Reboot after applying changes check box.
8 Click Next .
The
Select Clients tab is opened.
client_sccm.book Page 42 Tuesday, September 27, 2011 9:17 AM