Users Guide

Using DCIP 27
4 The Data Preview window opens where you can verify the configuration
information you have entered. Click
Next .
5 The Choose Target Collection window opens. The following options
are available:
• Add new computers only to the All Systems collection
• Add computers to the following location
6 To add the computer to the all systems collection:
a On the Choose Target Collection window, select Add new computers
only to the All Systems
collection.
b Click Next .The Summary window with details of the imported system
setting is displayed.
c Click Finish to apply settings.
7 To add the computer to a specific location:
a On the Choose Target Collection window, select the Add computers
to the following location
option.
b Browse to the location of the computer collection you want to add to.
c Click Next .The Summary window with details of the imported system
setting is displayed.
d Click Finish to apply settings.
Reboot To PXE / USB Custom Action
Windows PE may have an issue when you add a system hardware
configuration action to a task sequence. Windows PE does not correctly
recognize any newly-created disk partitions or any significant change to the
disk structure created after the initial Windows PE boot. This causes the task
sequence to fail during any task that writes data to the disk (including the
standard ConfigMgr reboot task).
To resolve this issue, you must insert custom reboot actions after you create
and partition a disk. If you are using
Pre-boot eXecution Environment ( PXE)
instead of boot media, you must reset the PXE advertisement in order to
reboot back into PXE.
You can insert the
Reboot to PXE/USB Custom Action into a task sequence
in one of the following ways:
client_sccm.book Page 27 Tuesday, September 27, 2011 9:17 AM