Reference Guide

Client Configuration Toolkit Options 23
-l or --logfile
No option
bootorder=legacytype,+pcmcia,+hdd.1,-floppy,+cdrom,-
hdd.2,+nic.1,-hdd.3,+nic.2
A plus ( + ) symbol with the device name indicates that the
device is enabled and a minus (
- ) symbol indicates that the
device is disabled. You can enable or disable the devices by
changing the symbol displayed with the device short name.
These symbols are optional and if not present, the current
status of the device is retained.
NOTE: If the operating system is booted in the UEFI mode, then the
bootorder type will be shown as uefitype.
Change the boot order by changing the order of the list. You can also
enter the device number instead of the device name.
NOTE: The bootorder option in the ini file is applied to a system based
on its active boot list. If the ini file is generated from a system with the
active boot list set as uefi, and it is applied on a system with the active
boot list set as legacy, the boot order is set only on devices that are
available in the system. It is recommended that you apply the ini file on
a system with the same active boot list as of the system from where the
ini file is generated.
Example C:\>cctk -i <c:/cctk>/filename.ini
Valid Argument <filename>
Description Logs the command line output to a time-stamped file. The utility
either appends the information to an existing log file or creates a
new file. The log file contains the same information as the standard
output, plus timestamp information. Users should use this option
instead of redirection for task diagnosis.
Example C:\>cctk -l <c:/cctk>/logfile
Valid Argument NA
Description If an option is not given, the CCTK utility outputs usage
information. The usage information is displayed in the format
shown below.