Setup Guide

8 Quick Installation Guide
– cctk-linux-version-buildnum.i386.rpm
– readme.txt
3 Install the RPMs in the following order:
a rpm –ivh srvadmin-ipmi-6.0.1-800.DUP.i386.rpm
b rpm –ivh srvadmin-omilcore-6.0.1-800.i386.rpm
c rpm –ivh srvadmin-hapi-6.0.1-800.i386.rpm
d rpm –ivh cctk-linux-version-buildnum.i386.rpm
4
To run CCTK commands, from the command prompt navigate to
/opt/dell/toolkit/bin directory. For more details on running the CCTK
commands, see
Dell Client Configuration Toolkit Command Line Interface
Reference Guide
.
NOTE: CCTK GUI is not supported on Linux systems.
Important Information
To run CCTK commands, you must install Hardware Application
Programming Interface (HAPI) version 5.9.4 on the system. The common
scenarios are:
• If the system does not have HAPI, when you run a CCTK command, HAPI
is installed automatically. After the option is configured, HAPI is
uninstalled.
• If the system has an older version of HAPI, when you run a CCTK
command, HAPI is automatically upgraded to the latest version. In this
scenario, HAPI is not downgraded to the earlier version.
• If you run CCTK commands frequently, it is recommended that you
install HAPI before you execute CCTK commands. To install HAPI:
a Navigate to the HAPI directory ( \X86 in 32-bit system and \X86_64 in
64-bit system).
b Run HAPIInstall.bat .
cctk_qig.book Page 8 Monday, July 25, 2011 3:00 PM