Users Guide

CCTK Options 33
If this option is used with other function command options, they are
applied in the order in which they appear on the command line, overriding
any previous commands.
In the
.ini file, bootorder is displayed as a list of comma separated device
short forms in the order they are assigned.
For example:
bootorder=+pcmcia,+hdd.1,-floppy,+cdrom,-
hdd.2,+nic.1,-hdd.3,+nic.2
A plus ( + ) symbol with the device name indicates that the device is
enabled and a minus (
- ) symbol indicates that the device is disabled. You
can enable or disable the devices by changing the
+ or - symbol displayed
with the device short name. These symbols are optional and if not present,
the current status of the device is retained.
Change the boot order by changing the order of the list. You can also enter
the device number instead of the device name.
NOTE: The bootorder option in the ini file will be applied to a system based on
its active boot list. If the ini file is generated from a system with the active boot
list set as uefi, and it is applied on a system with the active boot list set as
legacy, the boot order is set only if the devices are available in the system. It is
recommended that you apply the ini file on a system with the same active boot
list as of the system from where the ini file is generated.
Example
A:>cctk -i <c:/cctk>/filename.ini
-l or --logfile
Valid Argument
< filename >
Description
Logs the command line output to a time-stamped file. The utility either
appends the information to an existing log file or creates a new file.
The log file contains the same information as the standard output,
plus timestamp information. Users should use this option instead of
redirection for task diagnosis.