Setup Guide

46 Configuring Storage
• One or Two Direct-Attached Servers, Single-Path Data, Single Controller
(Simplex)
— This configuration contains one or two XenServer hosts,
each with one Network Identification Card (NIC) for iSCSI connectivity,
and an PowerVault MD3000i storage array enclosure with one RAID
controller. One port of each host's NIC is connected to one port on the
PowerVault MD3000i RAID controller. Two optional PowerVault MD1000
storage enclosures can be daisy-chained to the PowerVault MD3000i
storage array to provide additional storage capacity.
XenServer hosts 1 and 2
as shown in Figure 5-13 cannot be a part of a pool.
Figure 5-13. PowerVault MD3000i Storage Array – One or Two Direct-Attached Servers,
Single-Path Data, Single Controller (Simplex)
LAN
XenServer Host 1 & 2
NIC 0 NIC 0
MD3000i
Controller 0
Port 1
Controller 0
Port 0
PowerVault MD1000
(optional) storage array
PowerVault MD1000
(optional) storage array