Setup Guide

Installing and Configuring Citrix XenServer Dell Edition 15
Installing and Configuring Citrix
XenServer Dell Edition
This section describes steps to install and setup the first boot for a Citrix
®
XenServer
®
Dell™ Edition host.
Installing XenServer Dell Edition
If you downloaded XenServer Dell Edition from the Citrix or Dell website,
you must install the software on your system.
NOTE: If your XenServer host was factory-installed at Dell, you can skip the
following installation steps and proceed to "Configuring the XenServer Host" on
page 16.
To install XenServer:
1
Burn the downloaded ISO image to a media.
2 Insert the XenServer Installation media into the optical drive of the system
and boot to the media.
3 Select the installation target (flash device).
4 Select Removable media when you are prompted for an image media.
5 Confirm your selections.
The installer partitions the target device and the installation begins.
The time required to install XenServer Dell Edition varies according to
the size of the target device.