Setup Guide

Appendix 67
Driver version: 7.6.9.2-NAPI
Firmware version: 5.6-2
Bus Info: 0000:0b:00.0
PCI name : 0000:0b:00.0
PCI Slot : 4
BIOS device: eth3
Kernel name: eth3
Permanant MAC: 00:15:17:24:A4:B1
Assigned MAC : 00:15:17:24:A4:B1
Driver: e1000
Driver version: 7.6.9.2-NAPI
Firmware version: 5.6-2
Bus Info: 0000:0b:00.1
PCI name : 0000:0b:00.1
PCI Slot : 4
The BIOS device name is the name suggested by the system BIOS. The BIOS
device name is used by the XenServer kernel to enumerate the device name.
As shown in the above output, the PCI slot and the System Management BIOS
(SMBIOS) instance fields for eth0 and eth1 display that these devices are two
LOM NIC ports on the system. Fields PCI slot filed for eth2 and eth3 display
that these devices are two ports on a dual port network adapter present in the
PCI slot number 4.
The BIOS device name field must match the kernel name field. In rare cases,
after the XenServer boots for the first time, the BIOS device name may not
match the kernel device name. To resolve this issue, log in to the XenServer local
console shell and restart the xapi service by running the following command:
# service xapi restart