Users Guide

<duplex mode> is 0 (half duplex) or 1 (full duplex, default)

racadm config -g cfgNetTuning -o cfgNetTuningNicSpeed <speed>

where:

<speed> is 10 or 100 (default).

Setting the Maximum Transmission Unit for IPv4 and IPv6

The Maximum Transmission Unit (MTU) property allows you to set a limit for the largest packet that can be passed through the interface.

To set the MTU, type:

racadm config -g cfgNetTuning -o cfgNetTuningMtu <mtu>

where <mtu> is a value between 576–1500 (inclusive; default is 1500).

NOTE: IPv6 requires a minimum MTU of 1280. If IPv6 is enabled, and cfgNetTuningMtu is set to a lower value, the

CMC uses an MTU of 1280.

Configuring CMC Network and Login Security

Settings

The IP address blocking and User blocking features in CMC allow you to prevent security issues due to password guessing attempts. This

feature enables you to block a range of IP addresses and users who can access CMC. By deafult, the IP address blocking feature is

enabled in CMC. You can set the IP range attributes using CMC Web interface or RACADM. To use the IP address blocking and user

blocking features, enable the options using CMC web interface or RACADM. Configure the login lockout policy settings to enable you to

set the number of unsuccessful login attempts for a specific user or for an IP address. After exceeding this limit, the blocked user can log

in only after the penalty time expires.

NOTE: Blocking by IP address is applicable only for IPV4 addresses.

Configuring IP Range Attributes Using CMC Web Interface

NOTE: To perform the following task, you must have Chassis Configuration Administrator privilege.

To configure the IP range attributes using CMC Web interface:

1. In the system tree, go to Chassis Overview and click Network > Network. The Network Configuration page is displayed.

2. In the IPv4 Settings section, click Advanced Settings.

The Log in Security page is displayed.

Alternatively, to access the Log in Security page, in the system tree, go to Chassis Overview, click Security > Log in.

3. To enable the IP range checking feature, in the IP Range section, select the IP Range Enabled option.

The IP Range Address and IP Range Mask fields are activated.

4. In the IP Range Address and IP Range Mask fields, type the range of IP addresses and IP range masks that you want to block from

accessing CMC.

For more information, see the CMC Online Help.

5. Click Apply to save your settings.

Configuring IP Range Attributes Using RACADM

You can configure the following IP Range attributes for CMC using RACADM:

• IP range checking feature

• Range of IP addresses that you want to block from accessing CMC

• IP Range Mask that you want to block from accessing CMC

Configuring CMC