Manualshelf

Users Guide

ManualsBrandsDell ManualsActive System ManagerChassis Management Controller Version 6.21 For Dell PowerEdge M1000e
231232233234235236237238239240
Table 67. PSU Status
Item Description
Name/Location Example: PSU1, PSU2, and so on.
Error Messages If there are no errors then the message “No Errors” is displayed, else error messages are listed. Critical errors are
listed first, followed by warnings.
Status Offline, Online, or Standby.
Maximum Wattage Maximum Wattage that PSU can supply to the system.
Table 68. IOM Status
Item Description
Name/
Location
Example: IOM A1, IOM B1. and so on.
Error
Messages
If there are no errors then the message “No Errors” is displayed, else error messages are listed. Critical errors are listed
first, followed by warnings. For more information see LCD Error Messages.
Status Off or On.
Model Model of the IOM.
Fabric Type Networking type.
IP address Only shows if IOM is On. This value is zero for a pass through type IOM.
Service Tag The factory-assigned service tag.
Table 69. iKVM Status
Item Description
Name iKVM.
No Error If there are no errors then the message “No Errors” is displayed, else error messages are listed. Critical errors are listed
first, followed by warnings. For more information see LCD Error Messages.
Status Off or On.
Model/
Manufacture
A description of the iKVM model.
Service Tag The factory-assigned service tag.
Part Number The Manufacturer part number.
Firmware
Version
iKVM firmware version.
Hardware
Version
iKVM hardware version.
NOTE: This information is dynamically updated
Table 70. Server Status
Item Description
Example: Server 1, Server 2,
etc.
Name/Location.
No Errors If there are no errors then the message “No Errors” is displayed, else error messages are listed. Critical
errors are listed first, followed by warnings. For more information see LCD Error Messages.
Slot Name Chassis slot name. For example, SLOT-01.
NOTE: You can set this table through the CMC CLI or Web interface.
Name Name of the server, which the user can set through Dell OpenManage. The name is displayed only if
iDRAC has finished booting, and the server supports this feature, else iDRAC booting messages are
displayed.
Using LCD Panel Interface 231