CLI Guide

For more information about the options, see RACADM Subcommand Details. To download the local RACADM tool from

www.dell.com/support/home, click Servers, Storage & Networking in the General Support section. Click PowerEdge, click the

required PowerEdge system, and then click Drivers & downloads.

RACADM Syntax Usage

The following section describes the syntax usage for SSH or Telnet, and Remote RACADM.

NOTE: The RACADM command-line interface in CMC does not ignore single or double quotation. When you enter an

open quotation mark, ensure that you enter the close quotation mark too.

SSH, Telnet, or Remote RACADM

racadm -r <cmcIPAddr> -u username -p password <subcommand>

racadm -r <cmcIPAddr> -u username -p password getconfig -g <group name> -o <object name>

racadm <subcommand>

Example

racadm getsysinfo

racadm -r 192.168.0.2 -u username -p xxx getsysinfo

racadm -r 192.168.0.2 -u username -p xxx getconfig -g cfgchassispower

SSH or Telnet RACADM

racadm getconfig -g <groupname> [-o <objectname>][-i <indexnumber>]

racadm <subcommand>

Example

racadm getconfig -g idracinfo

racadm getsysinfo

Remote RACADM

racadm -r <cmcIPAddr> -u <username> -p <password> <subcommand>

Example

racadm -r 192.168.0.2 -u root -p xxxx getsysinfo

Security Alert: Certificate is invalid - Certificate is not signed by Trusted Third Party

Continuing execution.

NOTE:

The following command does not display a security error:

racadm -r 192.168.0.2 -u noble -p xxx getsysinfo --nocertwarn

RACADM Command Options

The following table lists the options for the RACADM command:

Introduction