CLI Guide

1 packets transmitted, 1 packets received, 0 percent packet lossround-trip

min/avg/max = 4.121/4.121/4.121 ms

ping6

Table 99. Details of ping6 attribute

Description

Verifies if the destination IPv6 address is reachable from CMC or with the current routing-table contents. A

destination IPv6 address is required. Based on the current routing-table contents, an ICMP echo packet is sent to

the destination IPv6 address.

To run this subcommand, you must have the Administrator privilege.

Synopsis

racadm ping6 <ipv6address>

Input <ipv6address> — the IPv6 address of the remote endpoint to ping.

Example

Pinging 2011:de11:bdc:194::31 from 2011:de11:bdc:194::101 with 32 bytes of

data:

Reply from 2011:de11:bdc:194::31: time<1ms

Ping statistics for 2011:de11:bdc:194::31:

Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),

Approximate round trip times in milli-seconds:

Minimum = 0ms, Maximum = 0ms, Average = 0ms

racdump

Table 100. Details of racdump attribute

Description Provides a single command to get dump, status, and general CMC board information.

This subcommand displays the comprehensive chassis status, configuration state information, and historic event

logs. Used for post deployment configuration verification and during debugging sessions.

To run this subcommand, you must have the Administrator privilege.

Racdump includes the following subsystems and aggregates the following RACADM commands:

• General System/RAC information — getsysinfo

• Session information — getssinfo

• Sensor information — getsensorinfo

• Switches information (IO Module) — getioinfo

• Mezzanine card information (Daughter card) — getdcinfo

• All modules information — getmodinfo

• Power budget information — getpbinfo

• KVM information — getkvminfo

• NIC information (CMC module) — getniccfg

• Redundancy information — getredundancymode

• Trace log information — gettracelog

• RAC event log — getraclog

• System event log — getsel

Synopsis

racadm racdump

Input N/A

70 RACADM Subcommand Details