CLI Guide

Help and help subcommand
Table 4. Help and help subcommand
Description
Lists all the subcommands available for use with RACADM and provides a short description about each
subcommand. You may also type a subcommand, group, object or Fully Qualified Descriptor (FQDD) name after
help.
Synopsis
• racadm help
• racadm help <subcommand>
•
racadm help —g <groupname>
• racadm help –g <groupname> —o <objectname>
Input
• <subcommand> — specifies the subcommand for which you need the help information.
• <device name> — specifies the device name such as iDRAC, BIOS, NIC, LifecycleController, FC, system, or
Storage.
• <group> — specifies the group name supported by the corresponding device.
• <object> — specifies the object for the entered group.
Output
• The help command displays a complete list of subcommands.
• The racadm help <subcommand> command displays information for the specified subcommand only.
• The racadm help —g <groupname> command displays information for the specified group.
• The racadm help —o <objectname> command displays information for the specified object.
• The racadm help <device name> <Group> command displays information for the specified group.
• The racadm help <device name> <Object> command displays information for the specified object.
• The racadm help <device name> <Group> <Object> command displays information for the
specified object.
arp
Table 5. arp table
Description
Displays the contents of the Address Resolution Protocol (ARP) table. ARP table entries cannot be added or
deleted.
To use this subcommand, you must have Execute Diagnostic Commands.
Synopsis
racadm arp
Input N/A
Example
racadm arp
Table 6. Output
Address HW Type HW Address Mask Device
192.168.1.1 Ether 00:0d:65:f3:7c:bf C eth0
chassisaction
Table 7. Details of chassisaction attribute
Description Runs a power action on the chassis, KVM or a switch.
To use this subcommand, you must have the Chassis Control Administrator privilege.
RACADM Subcommand Details 17