Users Guide

ManualsBrandsDell ManualsActive System ManagerChassis Management Controller Version 6.10 For Dell PowerEdge M1000e

261

262

263

264

265

266

267

268

269

270

Table 70. Server Status

Item Description

Example: Server 1, Server 2,

etc.

Name/Location.

No Errors If there are no errors then the message “No Errors” is displayed, else error messages are listed. Critical

errors are listed rst, followed by warnings. For more information see LCD Error Messages.

Slot Name Chassis slot name. For example, SLOT-01.

NOTE: You can set this table through the CMC CLI or Web interface.

Name Name of the server, which the user can set through Dell OpenManage. The name is displayed only if

iDRAC has nished booting, and the server supports this feature, else iDRAC booting messages are

displayed.

Model Number Displays if iDRAC nished booting.

Service Tag Displays if iDRAC nished booting.

BIOS Version Server BIOS rmware version.

Last POST Code Displays the last server BIOS POST code messages string.

iDRAC Firmware Version Displays if iDRAC nished booting.

NOTE: iDRAC version 1.01 is displayed as 1.1. There is no iDRAC version 1.10.

IP4 <enabled, disabled> Displays the current IPv4 enabled state.

IP4 Address: <address,

acquiring>

Only displays if IPv4 is enabled.

IP6 <enabled, disabled> Only displays if iDRAC supports IPv6. Displays current IPv6-enabled state.

IP6 Local Address: <address> Only displays if iDRAC supports IPv6 and IPv6 is enabled.

IP6 Global Address:

Only displays if iDRAC supports IPv6 and IPv6 is enabled.

FlexAddress enabled on

Fabrics

Only displays if the feature is installed. Lists the fabrics enabled for this server (that is, A, B, C).

The information in the table is dynamically updated. If the server does not support this feature, then the following information does not

appear, else Server Administrator options are as follows:

• Option “None” = No strings must be displayed on the LCD.

• Option “Default” = No Eect.

• Option “Custom” = Allows you to enter a string name for the server.

The information is displayed only if iDRAC has completed booting. For more information on this feature, see the Chassis Management

Controller for Dell PowerEdge M1000e RACADM Command Line Reference Guide at dell.com/support/manuals.

Using LCD Panel Interface

265