Users Guide

Table 64. CMC Status
Item Description
Example: CMC1, CMC2 Name or Location.
No Errors If there are no errors then the message “No Errors” is displayed, else error messages are listed. Critical errors
are listed rst, followed by warnings.
Firmware Version Only displays on an active CMC. Displays Standby for the standby CMC.
IP4 <enabled, disabled> Displays current IPv4 enabled state only on an active CMC.
IP4 Address: <address,
acquiring>
Only displays if IPv4 is enabled only on an active CMC.
IP6 <enabled, disabled> Displays current IPv6 enabled state only on an active CMC.
IP6 Local Address:
<address>
Only displays if IPv6 is enabled only on an active CMC.
IP6 Global Address:
<address>
Only displays if IPv6 is enabled only on an active CMC.
MAC: <address> Displays the CMC's MAC address.
Table 65. Chassis or Enclosure Status
Item Description
User Dene Name Example: “Dell Rack System”. You can set this option through the CMC Command Line Interface (CLI) or Web
interface.
Error Messages If there are no errors then the message “No Errors” is displayed, else error messages are listed. Critical errors are
listed rst, followed by warnings.
Model Number Example "PowerEdgeM1000e".
Power
Consumption
Current power consumption in watts.
Peak Power Peak power consumed in watts.
Minimum Power Minimum power consumed in watts.
Ambient
Temperature
Current ambient temperature in degrees Celsius.
Service Tag The factory-assigned service tag.
CMC redundancy
mode
Non-Redundant or Redundant.
PSU redundancy
mode
Non-Redundant, AC Redundant, or DC Redundant.
Table 66. Fan Status
Item Description
Name/Location Example: Fan1, Fan2, and so on.
Error Messages If no error then "No Errors" is shown; otherwise error messages are listed, critical errors rst, then warnings.
Using LCD Panel Interface 263