Users Guide
• MPCM is already enabled.
An alert message with the reason for ECM not getting enabled is displayed .
NOTE: If you try to enable MPCM when ECM is enabled, the ECM mode changes to enabled but unsupported state.
Conguring Enhanced Cooling Mode for Fans Using RACADM
To enable and congure the Enhanced Cooling Mode for fans, use the following RACADM object under the cfgThermal group:
cfgThermalEnhancedCoolingMode
For example, to enable the ECM mode, use:
racadm config –g cfgThermal –o cfgThermalEnhancedCoolingMode 1
In case of errors, an error message is displayed. The default value of Enhanced Cooling Mode option is disabled (0). This value is set to
disabled (0) when racresetcfg command is issued.
To view the current ECM mode, use:
racadm getconfig –g cfgThermal
To view the current state of ECM mode, use:
racadm getfanreqinfo
[Enhanced Cooling Mode]
Enhanced Cooling Mode(ECM) Status = Disabled
For more information, see the Chassis Management Controller for Dell PowerEdge M1000e RACADM Command Line Reference Guide
available at dell.com/support/manuals.
Conguring
CMC 107