Release Notes

Fixes

• Fixed an issue causing all the blades in the chassis to be in a 'not ready' state or 'iDRACs remain oine' during chassis power cycle.

Release 5.20

• Fixed an issue causing ash Media Status showing as "Version mismatch" during changeover or upgrade of the CMC.

• Fixed an issue that caused the Server Prole page to hang when a prole is applied to multiple servers.

• Fixed an issue limiting the speed of bNDC ports on some blades to 1 Gb after initial chassis turn on or blade insertion.

• Fixed an issue causing the slots 1-4 not initializing iDRAC after initial turn on.

Release 5.12

• Fixed an issue with Server/Host operating system (OS) network ap, which occurs occasionally on Modular platforms for a short

duration during CMC initialization.

• Fixed an issue with Server/Host OS network port o, which occurs after CMC is reset on full-height Modular platforms, when the

second network daughter card is not installed.

• Fixed an issue with the CMC web GUI becoming unresponsive while using Active Directory login with WinRM.

• Fixed an issue causing memory full condition when the internal log les are oversized.

• Fixed an issue causing non-display of some of the KVM-related information on the CMC web GUI.

Release 5.11

• Fixed an issue causing the health of the IOMs in slot 5 and 6 displaying "Not OK" on the CMC Interface for chassis with an IOM

installed in slot 6.

Release 5.10

• Fixed an issue causing partial display of IO-Identity values in the cmc getmacaddress -c all for Dual Port Network Card 10 GBE.

• Fixed an issue causing RACADM displays non ISCI MAC addresses after using ISCI lter in “getmacaddress –m server-x –t iscsi”

command.

• Fixed an issue causing ash media features showing invalid media for active controller after restoring the chassis backup.

Release 5.02

• Fixed an issue causing CMC redundancy loss in CMC 5.0.

• Fixed an issue causing the CMC Web GUI to become unresponsive in CMC 5.0.

Release 5.01

• Upgraded OpenSSL to version 1.0.1j.

• Updated NTP to version ntp-ssl-4.2.6p3.

• Upgraded Apache to version 2.4.10.

• Fixed PS-M4110 failure to boot issue in CMC 5.0.

• When an IOM is connected through Data Center Bridging, then PS-M4110 must be congured through its own serial port and cannot

be congured through CMC interfaces.

Fixes 11