CLI Guide

To run this subcommand, you must have the Congure Chassis Administrator privilege.
NOTE: This subcommand is only supported on the remote interface(s).
Synopsis
racadm krbkeytabupload [-f <filename>]
<filename> is the name of the le including the path.
Input -f — Species the lename of the keytab uploaded. If the le is not specied, the keytab le in the current
directory is selected.
Example Upload a kerberos keytab le from the local lesystem:
racadm krbkeytabupload -f c:\keytab\krbkeytab.tab
netstat
Table 96. Details of netstat attribute
Description Displays the routing table and the current connections.
To run this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis
racadm netstat
Input N/A
Table 97. Output - Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
0.0.0.0 100.101.17.1 0.0.0.0 UG 0 0 0 eth0
100.101.17.0 0.0.0.0 255.255.255
.0
U 0 0 0 eth0
Table 98. Output - Kernel IPv6 routing table
Destination Next Hop Flags Metric Ref Use If
2607:f2b:f08
8:17::/64
:: U 256 0 0 eth0
fe80::/64 :: U 256 0 0 eth0
ff00::/8 :: U 256 11196 053 eth0
::/0 :: U 1024 1 19 eth0
ping
Table 99. Details of ping attribute
Description Veries if the destination IP address is reachable from CMC with the current routing-table contents. A destination IP
address is required. Based on the current routing-table contents, an ICMP echo packet is sent to the destination IP
address.
68 RACADM Subcommand Details