Users Guide

Updating Server iDRAC Firmware Using Web Interface
To update the iDRAC rmware in the server using in the CMC Web interface:
1. Go to any of the following pages:
• Chassis Overview → Update
• Chassis Overview → Chassis Controller → Update
• Chassis Overview → I/O Module Overview → Update
• Chassis Overview → iKVM → Update
The Firmware Update page is displayed.
You can also update server iDRAC rmware at Chassis Overview → Server Overview → Update . For more information, see
the Updating Server Component Firmware.
2. To update iDRAC rmware, in the iDRAC Enterprise Firmware section, select the check box in the Update Targets column for
the iKVM you want to update the rmware and click Apply iDRAC Enterprise Update and go to step 4.
3. To update iDRAC rmware, in the iDRAC Enterprise Firmware section, click the Update link for the server you want to update
the rmware.
The Server Component Update page is displayed. To continue, see the Updating Server Component Firmwaresection.
4. In the Firmware Image eld, enter the path to the rmware image le on the management station or shared network, or click
Browse to navigate to the le location. The default iDRAC rmware image name is rming.imc.
5. Click Begin Firmware Update and then click Yes to continue.
The Firmware Update Progress section provides rmware update status information. A status indicator displays on the page
while the image le uploads. File transfer time varies based on connection speed. When the internal update process begins, the
page automatically refreshes and the Firmware update timer is displayed.
6. Additional instructions to follow:
• Do not click the Refresh icon or navigate to another page during the le transfer.
• To cancel the process, click Cancel File Transfer and Update. This option is available only during le transfer.
• The Update State eld displays the rmware update status.
NOTE: It may take up to 10 minutes to update the iDRAC rmware.
When the update is complete, iKVM resets and the new rmware is displayed on the Firmware Update page.
Updating Server iDRAC Firmware Using RACADM
To update iDRAC rmware using RACADM, use the fwupdate subcommand. For more information, see Chassis Management
Controller for Dell PowerEdge M1000e RACADM Command Line Reference Guide for iDRAC and CMC.
Updating Server Component Firmware
The one-to-many update feature in CMC enables you to update server component rmware across multiple servers. You can update
the server components using the Dell Update Packages available on the local system or on a network share. This operation is
enabled by leveraging the Lifecycle Controller functionality on the server.
NOTE: To update component rmware, the CSIOR option must be enabled for servers. To enable CSIOR on:
• 11th generation servers — After restarting the server, from the CTRL-E setup, select System Services, enable CSIOR,
and then save the changes.
• 12th generation servers and later— After restarting the server, from the F2 setup, select iDRAC Settings → Lifecycle
Controller, enable CSIOR and save the changes.
The Update from File method enables you to update the server component rmware using DUP les stored on a local system. You
can select the individual server components to update the rmware using the required DUP les. You can update large number of
components at a time by using an SD Card to store DUP le of more than 48 MB memory size.
49