Users Guide

• 0 — not blinking (default)
• 1 — blinking
Conguring CMC Properties
You can congure CMC properties such as power budgeting, network settings, users, and SNMP and email alerts using the Web
interface or RACADM.
Conguring iDRAC Launch Method Using CMC Web Interface
To congure the iDRAC launch method from the General Chassis Settings page:
1. In the system tree, click Chassis Overview → Setup.
The General Chassis Settings page is displayed.
2. In the drop-down menu for the iDRAC Launch Method property, select IP Address or DNS.
3. Click Apply.
NOTE: A DNS-based launch is used for any particular iDRAC only if:
• The chassis setting is DNS.
• CMC has detected that the specic iDRAC is congured with a DNS name.
Conguring iDRAC Launch Method Using RACADM
To update CMC rmware using RACADM, use the cfgRacTuneIdracDNSLaunchEnable subcommand. For more information,
see the Chassis Management Controller for Dell PowerEdge M1000e RACADM Command Line Reference Guide.
Conguring Login Lockout Policy Attributes Using CMC Web Interface
NOTE: To perform the following steps, you must have Chassis Conguration Administrator privilege.
The Log in Security enables you to congure the IP range attributes for CMC login using the CMC Web interface. To congure the
IP range attributes using CMC Web interface:
1. In the system tree, go to Chassis Overview and click Network → Network.
The Network Conguration page is displayed.
2. In the IPv4 Settings section, click Advanced Settings. Alternatively, to access the Log in Security page, in the system tree, go
to Chassis Overview, click Security → Log in.
The Log in Security page is displayed.
3. To enable the user blocking or IP blocking feature, in the Login Lockout Policy section, select Lockout by User Name or
Lockout by IP Address (IPV4).
The options to set the other login lockout policy attributes are activated.
4. Enter the required values for login lockout policy attributes in the activated elds — Lockout Fail Count, Lockout Fail Window,
and
Lockout Penalty Time. For more information, see the CMC Online Help.
5. To save these settings, click Apply.
Conguring Login Lockout Policy Attributes Using RACADM
You can use RACADM to congure the Login lockout policy attributes for the following features:
• User blocking
• IP address blocking
• Number of login attempts allowed
• Timespan for the lockout failure counts to occur
• Lockout penalty time
35