CLI Guide

Output
Success: Test e-mail sent successfully
Failure: Unable to send test e-mail
Example
• Send a test email to the destination email address congured for index 1
racadm testemail -i 1
testfeature
Description Tests CMC feature x.
Synopsis
• racadm testfeature -f AD -u <user_at_domain> -p <password> [-d <debug_level>]
• racadm testfeature -f ADKRB -u <user_at_domain> -p <password> [-d
<debug_level>]
• racadm testfeature -f LDAP -u <user> -p <password> [-d <debug_level>]
Input
• -f <feature> — options are:
• AD — Test AD using simple authentication
• ADKRB — Test AD using Kerberos authentication
• LDAP — Test Generic LDAP
• -u <user>— On the basis of a feature, <user> is user or user_at_domain.
• -p <password> — Password for the user.
• -d <debug_level> — The following bitmask:
• 0x00 — quiet
• 0x01 — verbose
• 0x02 — debug
• 0x04 — info
• 0x08 — warning
• 0x10 — errors
• 0x20 — fatal
• 0x40 — checks
• 0xff — all debug information
• 0xd0 — default debug level for AD and ADKRB.
• 0xf0 and 0xf2 — default debug level for LDAP.
NOTE: -d option is only supported on the rmware interface or rmware interfaces.
Example
• To test AD.
racadm testfeature -f AD -u [e-mail] -p dell123
• To test ADKRB:.
racadm testfeature -f ADKRB -u [e-mail]
•
To test LDAP.
racadm testfeature -f LDAP -u joe -p dell123 -d 0xf2
testtrap
Description
Tests the RAC’s SNMP trap alerting feature by sending a test trap from CMC to a specied destination trap listener
on the network.
RACADM Subcommand Details 83