CLI Guide
–Displays the status of active features.
-d
–Deactivates feature specied in -c option.
NOTE: When the FlexAddress and FlexAddressPlus feature are active, deactivating one of them results in
deactivation of the other feature also.
-r
—Reformats damaged or unformatted extended storage media.
CAUTION: Using the -r switch deactivates the extended storage feature, if active; reformats the SD card
in the active CMC card slot; and may Restart the active CMC.
-c
— <featurename> — must be one of the following:
• flexAddress
• flexAddressPlus
• ExtendedStorage (with -d, or -r)
NOTE: The —a option is not supported for CMC 5.0.
Example
• Display the current status of all chassis features:
racadm feature -s
• Deactivate the FlexAddressPlus feature on the chassis:
racadm feature -d -c FlexAddressPlus
featurecard
Description
Veries proper SD card installation and displays the SD card status.
To use this subcommand, you must have the Chassis Conguration Administrator privilege.
Synopsis
racadm featurecard -s
Input
-s — Lists active SD card features and SD card status.
Output
• No feature card inserted — Action: To verify that the SD card was properly inserted, check the CMC.
In a redundant CMC conguration, make sure the CMC with the SD feature card installed is the active CMC and
not the standby CMC.
• The feature card inserted is valid and contains the following feature(s)
FlexAddress: The feature card is bound to this chassis
— Action: No action required.
• No features active on the chassis — Action: Install the SD card into the CMC.
• The feature card inserted is valid and contains the following feature(s)
FlexAddress: The feature card is bound to another chassis, svctag = ABC1234,
SD card SN = 01122334455
Action: Remove the SD card; locate and install the SD card for the current chassis.
• The feature card inserted is valid and contains the following feature(s)
FlexAddress: The feature card is not bound to any chassis
Action: The feature card can be moved to another chassis, or can be reactivated on the current chassis. To
reactivate on the current chassis, enter racadm racreset until the CMC module with the feature card
installed becomes active.
26 RACADM Subcommand Details