CLI Guide

• To congure the single property of a group:
racadm config -g cfgSerial -o cfgSerialBaudRate
• To modify a user password:
racadm config -g cfgUserAdmin -o cfgUserAdminPassword -i 3 <newpassword>
• To congure the single property of a group for a particular server:
racadm config -g cfgSessionManagement -o cfgSsnMgtWebServerTimeout newvalue -
m server-n
• To congure the remote Syslog property for a particular server:
racadm config -g cfgRemoteHosts -o cfgRhostsSyslogEnable 1 -m server-n
• To congure the remote Syslog property for all servers:
racadm config -g cfgRemoteHosts -o cfgRhostsSyslogEnable 1 -m server-all
• Congures the Enhanced Cooling Mode property for fans.
racadm config –g cfgThermal –o cfgThermalEnhancedCoolingMode 1
connect
Description Connects to the switch or blade server serial console.
NOTE: This subcommand is only supported on the rmware interface(s).
Synopsis
• racadm connect [-b] —m <module>
Input
-b — Connects to the switch or console using the binary mode. -b is an optional; a server or a switch must be
present.
NOTE: If you use the -b option, reset the CMC to end the connect operation.
-m <module> — Must be one of the following values:
• server –<n> — where n=1–16
• server –<nx> — where n=1–8; x = a, b, c, d (lower case)
• switch –<n> — where n = 1 to 6 or <a1 | a2 | b1 | b2 | c1 | c2>
Example
• Connect to I/O Module 1 serial console:
racadm connect -m switch-1
• Connect to server 1 serial console:
racadm connect -m server-1
deploy
Description
Deploys blade server or IOM by specifying the required properties.
To use this subcommand, you must have the Server Administrator privilege.
NOTE: Use setniccfg to congure static IP address, subnet mask, and gateway, and DHCP, speed and
duplex properties.
Synopsis
• racadm deploy -m server-<n> -u root -p <password> -s <ipaddress> <subnet>
<gateway> -b <device> -o no | yes
• racadm deploy -m server-<n> -u root -p <password>-s -6 <ipv6Address>
<prefixlen> <gateway> -b <device> -o no | yes
where <prefixlen> must be a number between 0 and 128.
•
racadm deploy -m server-<n> -u root -p <password> -d [-6]
22 RACADM Subcommand Details