CLI Guide

Server-3 Present ON OK BCD1234 BCD1234
Server-4 Present ON OK BCD1234 BCD1234
Server-5 Present ON OK BCD1234 BCD1234
Server-6 Present ON OK BCD1234 BCD1234
Server-7 Present ON OK BCD1234 BCD1234
Server-8 Present ON OK BCD1234 BCD1234
Server-9 Present ON OK BCD1234 BCD1234
Server-10 Present ON OK ABC1234 ABC1234
Server-11 Present ON OK ABC1234 ABC1234
Server-12 Present ON OK BCD1234 BCD1234
Server-13 Present ON OK BCD1234 BCD1234
Server-14 Present ON OK ABC1234 ABC1234
Server-15 Present ON OK BCD1234 BCD1234
Server-16 Present ON OK BCD1234 BCD1234
KVM Present ON OK N/A N/A
IO-Cable Present ON OK noble01 N/A
FPC-Cable Present ON OK noble01 N/A
NOTE: A power state of "Primary" denotes Active CMC.
getniccfg
Description
Displays the current NIC settings.
Synopsis
racadm getniccfg [-m <module>]
Input
–m <module> must be one of the following values:
● chassis : Default state if -m is not specified.
● server-<n> : where n=1–16
● server-<nx> : where n=1–8; x = a, b, c, d (lower case)
● switch-<n> : where n=1–6
Output
The getniccfg subcommand displays an appropriate error message if the operation is not successful.
Otherwise, the output is displayed in the following format:
IPv4 settings:
NIC Enabled =1
IPv4 Enabled =1
DHCP Enabled =1
IP Address =10.94.225.165
Subnet Mask =255.255.255.128
Gateway =10.94.225.129
IPv6 settings:
56 RACADM Subcommand Details