Release Notes

Release 5.00
• Upgraded an open source component of WS-MAN namely Small Footprint CIM Broker (SFCB) from
1.3.10 to 1.3.17, where CIM is Common Information Model.
• Fine-tuned memory monitoring daemons.
Important Notes
• While using Remote RACADM client with CMC 5.21 version, make sure that Remote RACADM client
version 8.0.2 is installed.
• When Certificate Validation is Enabled, FQDN of the system must be provided. If IP address of the
Domain Controller is specified when certificate validation is enabled, then the Active Directory login does
not work.
• Microsoft Windows Server 2012, Windows Server 2008 R2, Windows 7 do not support TLS 1.2 and TLS
1.1. Install update below to enable TLS 1.2 and TLS 1.1 as a default secure protocols in WinHTTP in
Windows. For details, see the Microsoft knowledge base article 3140245 at support.microsoft.com.
• Supports LDAP authentication with OPEN-DS. OPEN-DS must have DH key larger than 768 bits.
Known Issues
Issue 1:
Description
XWKGY_Intel10G card shows Flex disabled address after racresetcfg of CMC in Network Device page and OS.
Resolution
Virtual reseat or Physical reseat of the server.
Versions/Systems Affected
All CMC versions including CMC 5.21 and PowerEdge servers with iDRAC7 or earlier.
Issue 2:
Description
An error occurs while importing CMC configuration file using local racadm or remote racadm.
Resolution
This issue occurs when IPv6 is enabled or disabled from the configuration file. Enable or disable IPv6 using the
command, “racadm config -g cfgIPv6LanNetworking -o cfgIPv6Enable 0”.
Versions/Systems Affected
CMC version 5.11 or later
Issue 3:
Description
When CMC firmware is downgraded to 4.50 from 5.00 or later while network share is configured, the Server
Components Update page gets corrupted.
Resolution
Clear the network configuration before downgrading to 4.50
Versions/Systems Affected
CMC version 4.50 or earlier