Release Notes

Fixes
Release 5.21
N/A
Release 5.20
• Fixed an issue causing flash Media Status showing as "Version mismatch" during changeover or upgrade
of the CMC.
• Fixed an issue causing the
Server Profile
page to hang when a profile is applied to multiple servers.
• Fixed an issue limiting the speed of bNDC ports on some blades to 1 Gb after initial chassis turn on or
blade insertion.
• Fixed an issue causing the slots 1-4 not initializing iDRAC after initial turn on.
Release 5.12
• Fixed an issue with Server/Host operating system (OS) network flap, which occurs occasionally on
Modular platforms for a short duration during CMC initialization.
• Fixed an issue with Server/Host OS network port off, which occurs after CMC is reset on full-height
Modular platforms, when the second network daughter card is not installed.
• Fixed an issue causing the CMC web GUI to become unresponsive while using Active Directory login with
WinRM.
• Fixed an issue causing memory full condition when the internal log files are oversized.
• Fixed an issue causing non-display of some of the KVM-related information on the CMC web GUI.
Release 5.11
• Fixed an issue causing the health of the IOMs in slot 5 and 6 displaying "Not OK" on the CMC Interface
for chassis with an IOM installed in slot 6.
Release 5.10
• Fixed an issue with the "getmacaddress -c all” command displaying partial IO Identity values for the Intel
Dual Port Network Card 10 GBE.
• Fixed an issue with the “getmacaddress –m server-x –t iscsi” command displaying non-iSCSI MAC
addresses after using the iSCSI filter.
• Fixed an issue with flash media features displaying invalid media for active controllers after restoring the
chassis.
Release 5.02
• Fixed an issue causing CMC redundancy loss in CMC 5.0.
• Fixed an issue causing the CMC Web GUI to become unresponsive in CMC 5.0.
Release 5.01
• Upgraded OpenSSL to version 1.0.1j.
• Updated NTP to version ntp-ssl-4.2.6p3.
• Upgraded Apache to version 2.4.10.
• Fixed PS-M4110 failure to boot issue in CMC 5.0.
• When an IOM is connected through Data Center Bridging, then PS-M4110 must be configured through
its own serial port and cannot be configured through CMC interfaces.
• Fixed the power budgeting issue that occurs when SPOR is disabled.