Users Guide

You can also congure iDRAC from the CMC GUI.
10 Select the Internet Protocol (IPv4, IPv6, or both) that you want to use for the servers.
Dynamic Host Conguration
Protocol (DHCP)
iDRAC retrieves IP conguration (IP address, mask, and gateway) automatically from a
DHCP server on your network. The iDRAC is assigned a unique IP address allotted over your
network. Press the center button.
Static You must manually enter the IP address, gateway, and subnet mask in the screens following
immediately.
If you have selected the Static option, press the center button to continue to the next
iDRAC Network Settings screen, then:
• Set the Static IP Address by using the right or left arrow keys to move between
positions, and the up and down arrow keys to select a number for each position. This
address is the static IP of the iDRAC located in the rst slot. The static IP address of
each subsequent iDRAC is calculated as a slot number increment of this IP address.
When you have nished setting the Static IP Address, press the center button to
continue.
• Set the subnet mask, and then press the center button.
• Set the gateway, and then press the center button.
• Select whether to Enable or Disable the IPMI LAN channel. Press the center button to continue.
• On the iDRAC Conguration screen, to apply all iDRAC network settings to the installed servers, highlight the Accept/Yes icon
and press the center button. To not apply the iDRAC network settings to the installed servers, highlight the No icon and press the
center button and continue to step c.
• On the next iDRAC Conguration screen, to apply all iDRAC network settings to newly installed servers, highlight the Accept/Yes
icon and press the center button; when a new server is inserted into the chassis, the LCD prompts the user on whether to
automatically deploy the server using the previously congured network settings/policies. To not apply the iDRAC network
settings to newly installed servers, highlight the No icon and press the center button; when a new server is inserted into the
chassis, the iDRAC network settings do not get congured.
11 On the Enclosure screen, to apply all enclosure settings highlight the Accept/Yes icon and press the center button. To not apply the
enclosure settings, highlight the No icon and press the center button.
12 On the IP Summary screen, review the IP addresses you provided to make sure the addresses are accurate. To correct a setting,
navigate to the left arrow button and then press the center key to return to the screen for that setting. After making a correction,
press the center button. If necessary, navigate to the right arrow button and then press the center key to return to the IP Summary
screen.
When you have conrmed that the settings you entered are accurate, press the center button. The Conguration Wizard closes and
returns you to the Main Menu screen.
NOTE
: If you selected Yes/Accept, a Wait screen is displayed before the IP Summary screen is displayed.
CMC and iDRACs are now available on the network. You can access the CMC on the assigned IP address using the Web interface or
CLIs such as a serial console, Telnet, and SSH.
NOTE
: After you have completed network set up through the LCD Conguration Wizard, the Wizard is no longer
available.
Interfaces y protocolos para obtener acceso al CMC
Una vez denida la conguración de red de la CMC, puede acceder de forma remota a la CMC mediante varias interfaces. En la siguiente
tabla se presentan las interfaces que puede utilizar para acceder a la CMC de forma remota.
NOTA
: Dado que no ofrece tanta seguridad como las otras interfaces, Telnet viene desactivada de manera predeterminada. Para
activar Telnet, use la Web, ssh o RACADM remoto.
NOTA: Si se utiliza más de una interfaz al mismo tiempo, se pueden obtener resultados inesperados.
32 Instalación y conguración del CMC