Users Guide

The Enclosure screen displays the following question: Congure Enclosure?
• Press the center button to continue to CMC Network Settings screen. See step 4.
• To exit the Congure Enclosure menu, select the NO icon and press the center button. See step 9.
3 Press the center button to continue to CMC Network Settings screen.
4 Select the network speed (10Mbps, 100Mbps, Auto (1 Gbps)) using the down arrow button.
The Network Speed setting must match your network conguration for eective network throughput. Setting the Network Speed
lower than the speed of your network conguration increases bandwidth consumption and slows network communication. Determine
whether your network supports the above network speeds and set it accordingly. If the network conguration does not match any
of these values, it is recommended to use Auto Negotiation (the Auto option) or refer to your network equipment manufacturer.
Press the center button to continue to the next CMC Network Settings screen.
5 Select the duplex mode (half or full) that matches the network environment.
NOTE: The network speed and duplex mode settings are not available if Auto Negotiation is set to On or 1000MB
(1Gbps) is selected.
If auto negotiation is turned on for one device but not the other, then the device using auto negotiation can determine the network
speed of the other device, but not the duplex mode; in this case, duplex mode defaults to the half duplex setting during auto
negotiation. Such a duplex mismatch results in a slow network connection.
Press the center button to continue to the next CMC Network Settings screen.
6 Select the Internet Protocol (IPv4, IPv6, or both) that you want to use for CMC and press the center button to continue to the next
CMC Network Settings screen.
7 Select the mode in which CMC must obtain the NIC IP addresses:
Dynamic Host
Conguration
Protocol (DHCP)
CMC retrieves IP conguration (IP address, mask, and gateway) automatically from a DHCP
server on your network. CMC is assigned to a unique IP address allotted over your network.
If you have selected the DHCP option, press the center button. The Congure iDRAC
screen appears; go to step 9.
Static You manually enter the IP address, gateway, and subnet mask in the screens that
immediately follows:
If you have selected the Static option, press the center button to continue to the next CMC
Network Settings screen, then:
• Set the Static IP Address by using the right or left arrow keys to move between
positions, and the up and down arrow keys to select a number for each position. When
you have nished setting the Static IP Address, press the center button to continue.
• Set the subnet mask, and then press the center button.
• Set the gateway, and then press the center button. The Network Summary screen
displays.
The Network Summary screen lists the Static IP Address, Subnet Mask, and Gateway
settings you entered. Check the settings for accuracy. To correct a setting, navigate to
the left arrow button then press the center key to return to the screen for that setting.
After making a correction, press the center button.
• When you have conrmed the accuracy of the settings you entered, press the center
button. The Register DNS? screen appears.
NOTE: If the Dynamic Host Conguration Protocol (DHCP) mode is
selected for CMC IP conguration, then DNS registration is also enabled
by default.
8 If you selected DHCP in the previous step, go to step 10.
To register your DNS server’s IP address, press the center button to proceed. If you have no DNS, press the right arrow key. The
Register DNS? screen appears; go to step 10.
Set the DNS IP Address using the right or left arrow keys to move between positions, and the up and down arrow keys to select a
number for each position. When you have nished setting the DNS IP address, press the center button to continue.
9 Indicate whether you want to congure iDRAC:
• No: Skip to step 13.
• Yes: Press the center button to proceed.
Instalación y
conguración del CMC 31