Users Guide

NOTE: The IP address set on the IOMs from CMC is not saved to the switch's permanent startup configuration. To

save the IP address configuration permanently, you must enter the connect switch-n command, or racadm

connect switch -n RACADM command, or use a direct interface to the IOM GUI to save this address to the

startup configuration file.

NOTE: The SNMP community string can have any printable character whose ASCII value is the range, 33–125.

4. Click Apply.

The network settings are configured for the IOM(s).

NOTE: For IOMs that are manageable, you can reset the VLANs, network properties, and IO ports to default

configurations.

Configuring Network Settings for IOMs Using RACADM

To configure the network settings for IOMs using RACADM, set the date and time. See the deploy command section in the Chassis

Management Controller for Dell PowerEdge M1000e RACADM Command Line Reference Guide.

You can set the username, password, and SNMP string for an IOM using the RACADM deploy command:

racadm deploy -m switch-<n> -u root -p <password>

racadm deploy -m switch-<n> -v SNMPv2 <snmpCommunityString> ro

racadm deploy -a [server|switch] -u root -p <password>

Resetting IOM to Factory Default Settings

You can reset IOM to the factory default settings using the Deploy I/O Modules page.

NOTE: This feature is supported on PowerEdge M I/O Aggregator IOM only. Other IOMs including MXL 10/40GbE are

not supported.

To reset the selected IOMs to factory default settings using the CMC Web interface:

1. In the system tree, go to I/O Module Overview and click Setup or expand I/O Module Overview in the system tree, select the

IOM, and click Setup.

The Deploy I/O Modules page displays the IOM(s) that are powered on.

2. For the required IOM(s), click Reset.

A warning message is displayed.

3. Click OK to continue.