Reference Guide

• -t: specify the le type to be imported. The valid value is xml. This option is case-insensitive.

Example

• Congure event lter congurations from a conguration le using remote racadm

racadm -r 192.168.0.120 -u <username> -p <password> set -f file.txt

• Congure a CMC from an XML conguration le on a local share using remote racadm

racadm -r 192.168.0.120 -u <username> -p <password> set -f

myfile.xml -t xml

• Congure a CMC from an XML conguration le on a remote CIFS share

racadm set -f myfile.xml -t xml -u myuser -p mypass -l //

192.168.0.0/myshare

• Congure a CMC from an XML conguration le on a remote NFS share

racadm set -f myfile.xml -t xml -l 192.168.0.0:/myshare

serveraction

Description Enables you to perform power management operations on the blade system.

To run this subcommand, you must have the Execute Server Control Commands permission.

Synopsis

• racadm serveraction -a <action>

• racadm serveraction -m <module> <action>

Input

• -m <module> — Must be one of the following values:

– server–<n>: where n=1–16

– server–<nx>: where n=1–8; x=a–d (enter lowercase letter only).

• -a — Performs power action on all servers. Not allowed with the powerstatus action.

<action> — Species the power management operation to perform. The options are:

• hardreset — Performs a force reset (reboot) operation on the managed system.

• powercycle — Performs a power-cycle operation on the managed system. This action is similar to

pressing the power button on the system’s front panel to turn o and then turn on the system.

NOTE: The -m and -a options are applicable only to CMC platforms.

NOTE: If the server is in turned o state, the powercycle option power-up the server.

• powerdown — Powers down the managed system.

• powerup — Powers up the managed system.

• powerstatus — Displays the current power status of the server (ON or OFF).

• graceshutdown — Performs a graceful shutdown of the server. If the operating system on the server

cannot shut down completely, then this operation is not performed.

• nmi — Generates the Non-masking interrupt (NMI) to halt the system operation. The NMI sends a high-

level interrupt to the operating system, which causes the system to halt the operation to allow critical

diagnostic or troubleshooting activities.

NOTE:

The halt system operation does not occur on systems running the Linux operating system.

• -f — Force the server power management operation.

• reseat — Performs virtual reseat of the server. This operation simulates reseating the blade by resetting

the iDRAC on that blade. -f is required for this operation.

NOTE: The actionpowerstatus is not allowed with -a option.

Output

Displays an error message if the requested operation is not completed, or a success message if the operation is

completed.