Reference Guide

– ipaddress — A string representing a valid IP address. For example, 192.168.0.20.

– subnet — A string representing a valid subnet mask. For example, 255.255.255.0.

– gateway — A string representing a valid gateway address. For example, 192.168.0.1.

• -d — Enables DHCP for the specied server.

The -s and -d options cannot be used together in the same command.

•

-6 — Enables IPv6 auto conguration (when used with -d). Sets static IPv6 addresses (when used with -

s).

• -v SNMPv2 <snmpCommunityString> ro — Species the SNMP community string for switches.

Valid community strings are 1–20 characters in length, with valid ASCII characters in the range [33–125]

(decimal). Protocol version set to SNMPv2. Permission on community string is read-only.

• -q — Displays or modies the quick deploy parameters.

• -n <numofblades> — Species the number of reserved IP addresses for quick deploy. The allowed

values are: 8, 16, and 32.

NOTE: The -q option must be specied with the -n option.

• -e — Uses the CMC DNS settings for quick deploy. The legal values are:

– 1 — Enable

– 0 — Disable

• --qd — Updates the quick deploy parameters to the servers. This option works only with the -q option.

Output None

Example

• Set root password, congure static IPV4 address, set rst boot device to HDD, and enable boot once for

server-1.

racadm deploy -m server-1 -u root -p <password> -s 192.168.0.20

255.255.255.0 192.168.0.1 -b HDD -o yes

• Set root password, congure static IPV6 address, set rst boot device to HDD, and enable boot once for

server-1.

racadm deploy -m server-1 -u root -p <password> -s -6 1 2001:DB8::2 64

2001:DB8::1 -b HDD -o yes

• Set root password and enable DHCP for server-3.

racadm deploy -m server-3 -u root -p <passpwrd> -d

• Set user name and password for switch-2.

racadm deploy -m switch-2 -u <username> -p <password>

• Set SNMP community string for switch-2.

racadm deploy -m switch-2 -v SNMPv2 DemoCommunityString ro

• Set root password to Calvin for all servers.

racadm deploy -a -u root -p calvin

• Set user name and password for all switches.

racadm deploy -a switch -u <username> -p <password>

• View the quick deploy parameters.

racadm deploy -q

• Modify the number of reserved IP addresses for quick deploy.

racadm deploy -q -n 8

eventlters

Table 4. eventlters

Description

Gets, sets, and displays the list of event lter settings.