Users Guide

Available Power in EPP Pool = 3167 W (10806 BTU/h)
Used Power in EPP Pool = 0 W (0 BTU/h)
EPP Percent - Available = 100.0
Scenario 3: Viewing EPP feature control operations recorded in CMC logs:
racadm getraclog
Jul 31 14:16:11 CMC-4C2WXF1 Log Cleared
Jul 31 14:15:49 CMC-4C2WXF1 Extended Power Performance is Enabled
Jul 31 14:15:49 CMC-4C2WXF1 Extended Power Performance is Disabled
Scenario 4: Changing Power configuration properties that are incompatible with EPP, when EPP is
enabled:
• Enabling Server Based Power Mangement (SBMP) on a 3000W AC PSU
racadm config -g cfgChassisPower -o cfgChassisServerBasedPowerMgmtMode 1
This feature is not supported while Extended Power Performance is enabled.
• Enabling Dynamic Power Supply Engagement on a 3000W AC PSU
racadm config -g cfgChassisPower -o cfgChassisDynamicPSUEngagementEnable 1
This feature is not supported while Extended Power Performance is enabled.
• Changing Power Redundancy Policy from Grid Redundancy Policy to PSU Redundancy Policy on a
3000W AC PSU
racadm config -g cfgChassisPower -o cfgChassisRedundancyPolicy 2
This feature is not supported while Extended Power Performance is enabled.
• Changing Power Redundancy Policy from Grid Redundancy Policy to No Redundancy Policy on a
3000W AC PSU
racadm config -g cfgChassisPower -o cfgChassisRedundancyPolicy 0
This feature is not supported while Extended Power Performance is enabled.
• Changing System Input Power Cap value to less than or equal to 13300 W
racadm config –g cfgChassisPower -o cfgChassisPowerCap 12500
System Input Power Cap cannot be set to less than or equal to 13300W
(45381 BTU/h)
while Extended Power Performance is enabled.
• Enabling 110VAC on a 3000W AC PSU
racadm config -g cfgChassisPower -o cfgChassisAllow110VACOperation 1
This feature is not supported on 3000W power supplies.
• Enabling Max Power Conservation Mode on a 3000W AC PSU
NOTE:
Max Power Conservation Mode (MPCM) can be enabled on 3000W AC PSU configuration, using
RACADM CLI with existing interface. There is no change to RACADM CLI interface for enabling MPCM,
while EPP is enabled.
Scenario 5: Trying to enable EPP from the disabled start condition, when other power configuration
settings are set.
• Enabling EPP on a 3000W AC PSU when System Input Power Cap is low
racadm config -g cfgchassispower -o cfgChassisEPPEnable
This feature is not supported while System Input Power Cap is set to less
than or equal to 13300 W (45381 BTU/h).
• Enabling EPP on a 3000W AC PSU when DPSE is Enabled
racadm config -g cfgChassisPower -o cfgChassisEPPEnable 1
This feature is not supported while Dynamic Power Supply Engagement is
enabled.
296