Users Guide

Table 47. Enclosure/Chassis Status Screen
Severity Message Cause
Critical Fan <number> is removed. This fan is required for proper cooling of the
enclosure/chassis.
Warning Power supply redundancy is degraded. One or more PSU have failed or removed and
the system can no longer support full PSU
redundancy.
Critical Power supply redundancy is lost. One or more PSU have failed or removed and
the system is no longer redundant.
Critical The power supplies are not redundant.
Insufficient resources to maintain normal
operations.
One or more PSU have failed or removed and
the system lacks sufficient power to maintain
normal operations. This could cause servers to
power down.
Warning The control panel ambient temperature is
greater than the upper warning threshold.
Chassis/Enclosure intake temperature
exceeded the warning threshold.
Critical The control panel ambient temperature is
greater than the upper warning threshold.
Chassis/Enclosure intake temperature
exceeded the warning threshold.
Critical CMC redundancy is lost. CMC no longer redundant. This happens if the
standby CMC is removed.
Critical All event logging is disabled. The Chassis/Enclosure cannot store events to
the logs. This usually indicates a problem with
the control panel or control panel cable.
Warning Log is full. Chassis has detected that only one more entry
can be added to the CEL (hardware log) before
it is full.
Warning Log is almost full. Chassis event log is 75% full.
Table 48. Fan Status Screens
Severity Message Cause
Critical Fan <number> RPM is operating less than
the lower critical threshold.
The speed of the specified fan is not sufficient
to provide enough cooling to the system.
Critical Fan <number> RPM is operating greater
than the upper critical threshold.
The speed of the specified fan is too high,
usually due to a broken fan blade.
Table 49. IOM Status Screens
Severity Message Cause
Warning A fabric mismatch detected on I/O module
<number>.
The IO module fabric does not match that of
the server or the redundant I/O module.
Warning A link tuning failure detected on I/O
module <number>.
The IO module could not be set to correctly
use the NIC on one or more servers.
277