Users Guide

The Apply Identity option is enabled.
3. Click Apply Identity.
A warning message is displayed that applying a new identity overwrites the current settings and also
reboots the selected server. You are prompted to confirm if you want to continue the operation.
NOTE: To perform server configuration replication operations on the server, the CSIOR option
must be enabled for the servers. If CSIOR option is disabled, a warning message is displayed
that CSIOR is not enabled for the server. To complete the server configuration replication
operation, enable the CSIOR option on the server .
4. Click OK to apply the boot identity profile to the selected server.
The selected profile is applied to the server and the server is rebooted immediately. For more
information, see the CMC Online Help.
Clearing Boot Identity Profiles
Before applying a new boot identity profile to a standby server, you can clear the existing boot identity
configurations of a selected server by using the Clear Identity option available in the CMC web interface.
To clear boot identity profiles:
1. Go to the Server Profiles page. In the Boot Identity profiles section, select the server from which
you want to clear the boot identity profile.
NOTE: This option is enabled only if any of the servers are selected and boot identity profiles
are applied to the selected servers.
2. Click Clear Identity.
3. Click OK to clear the boot identity profile from the selected server.
The clear operation disables the IO Identity and persistence policy of the server. On completion of
the clear operation, the server is powered off.
Viewing Stored Boot Identity Profiles
To view the boot identity profiles stored on the network share, go to the Server Profiles page. In the Boot
Identity Profiles → Stored Profiles section, select the profile and click View in the View Profile column.
The View Settings page is displayed. For more information on the displayed settings, see the CMC Online
Help.
Importing Boot Identity Profiles
You can import boot identity profiles that are stored on the management station to the network share.
To import a stored profile on to the network share from the management station, perform the following
tasks:
1. Go to the Server Profiles page. In the Boot Identity Profiles → Stored Profiles section, click Import
Profile
.
The Import Profile section is displayed.
2. Click Browse to access the profile from the required location and then click Import Profile.
For more information, see the CMC Online Help.
133