Users Guide

The following figure shows the QuickDeploy IP addresses assignment to the servers when there are 32
quarter height severs in a M1000e chassis:
Configuring Reserved QuickDeploy IP Addresses Using RACADM
To modify the number of static IP addresses allocated for servers on the chassis using RACADM, use the
following command:
racadm deploy –q -n <num>
where <num> is the number of IP addresses, 8. 16, or 32.
To view current settings for the number of reserved IP addresses and the Use CMC DNS Settings for
servers on the chassis using RACADM, use the following command:
racadm deploy –q
To modify the Use the CMC DNS Settings option to enable quick deploy for servers on the chassis using
RACADM, use the following command:
racadm deploy -q -e <enable/disable>
For more information, see the Chassis Management Controller for Dell PowerEdge M1000e RACADM
Command Line Reference Guide available at dell.com/support/manuals.
Modifying iDRAC Network Settings for Individual Server iDRAC
Using this table you can configure the iDRAC network configurations settings for each installed server.
The initial values displayed for each of the fields are the current values read from the iDRAC.
To modify the iDRAC Network Settings using the CMC Web interface:
1. In the system tree, go to Server Overview, and then click Setup → iDRAC. The Deploy iDRAC page is
displayed. The iDRAC Network Settings section lists all installed server’s iDRAC IPv4 and IPv6
network configuration settings.
2. Modify the iDRAC network settings as required for the servers.
NOTE: You must select the Enable LAN option to specify the IPv4 or IPv6 settings. For
information about the fields, see CMC Online Help.
3. To deploy the setting to iDRAC, click Apply iDRAC Network Settings. If you made changes to the
QuickDeploy settings, they are also saved.
The iDRAC Network Settings table reflects future network configuration settings; the values shown
for installed servers may or may not be the same as the currently installed iDRAC network
configuration settings. Click Refresh to update the iDRAC Deploy page with each installed iDRAC
network configuration settings after changes are made.
120