Users Guide

Setting Description
Enable iDRAC IPMI over LAN Enables or disables the IPMI over LAN channel
for each iDRAC present in the chassis.By default,
it is disabled.
Enable iDRAC DHCP Enables or disables DHCP for each iDRAC
present in the chassis. If this option is enabled,
the fields QuickDeploy IP, QuickDeploy Subnet
Mask, and QuickDeploy Gateway are disabled,
and cannot be modified since DHCP is used to
automatically assign these settings for each
iDRAC. By default, this option is disabled.
Reserved QuickDeploy IP Addresses Enables you to select the number of static IPv4
addresses reserved for the iDRACs in the chassis.
The IPv4 addresses starting from Starting iDRAC
IPv4 Address (Slot 1) are considered as reserved
and assumed to be unused elsewhere in the
same network. Quick Deploy feature does not
work for servers that are inserted into slots for
which there is no reserved static IPv4 address.
The maximum number of static IP Addresses
reserved for:
• Qurter-height servers are 32 IP addresses.
• Half-height servers are 16 IP addresses.
• Full-height servers are 8 IP addresses.
NOTE: Note the following:
• The values of the number of IP
addresses that are less than the
minimum value required for a server
type are grayed out.
• If you select an option that is lesser than
the default value of the number of IP
addresses reserved, an error message is
displayed warning that reducing the
number of IP addresses prevents quick
deploy of profiles to higher capacity
servers.
• A warning message is logged in the CMC
hardware log (SEL) and an SNMP alert is
generated.
• The quick deploy prompt on the LCD
panel is not displayed if a higher capacity
server is inserted in lower locations
when QuickDeploy feature is enabled.
To see the quick deploy option on the
LCD panel for the higher capacity
servers again change the IP addresses
value to the default value and reseat the
higher capacity servers.
NOTE:
117