Release Notes

Issue 3:
Description
Flash Media Status showing as "Version mismatch", when changeover the CMC or upgrade the CMC
Resolution
If chassis profile backup restore is performed on CMC-1 (active CMC) and changeover to CMC-2 (standby)
is done, there will be a version mismatch in the chassis configuration profile for extended storage in
CMC-2 after the changeover. The mismatch can be prevented by saving any server profile on CMC-1
before changing over to CMC-2. In case of version mismatch on CMC-2 after the changeover, the
changeover to CMC-1 can be performed to resolve the issue.
Versions/Systems Affected
All CMC versions including CMC 5.10
Limitations
Issue 1:
Description
While executing WSMAN commands continuously, WSMAN timeouts can occur occasionally, but get
resolved quickly without CMC failover or reboots.
Resolution
None
Versions/Systems Affected
All CMC versions including CMC 5.1.
Issue 2 (191858):
Description
The Server Profile page hangs after applying a profile to multiple servers.
Resolution
Do not perform any operations in GUI until the pop-up message is displayed in the GUI.
Versions/Systems Affected
CMC 5.1
Installation
Prerequisites
For information on pre-requisites, see the Dell PowerEdge M1000e Chassis Management Controller
Firmware Version 5.1 User's Guide
.
For information on Hardware and Software requirements, see the
Dell PowerEdge M1000e Chassis
Management Controller Firmware Version 5.1 User's Guide
.
For information on Installation and Configuration, see the
Dell PowerEdge M1000e Chassis Management
Controller Firmware Version 5.1 User's Guide
.