Release Notes

Release 5.02
• Fixed an issue causing CMC redundancy loss in CMC 5.0.
• Fixed an issue causing the CMC Web GUI to become unresponsive in CMC 5.0.
Release 5.01
• Upgraded OpenSSL to version 1.0.1j.
• Updated NTP to version ntp-ssl-4.2.6p3.
• Upgraded Apache to version 2.4.10.
• Fixed PS-M4110 failure to boot issue in CMC 5.0
• When an IOM is connected through Data Center Bridging, then PS-M4110 must be configured
through its own serial port and cannot be configured through CMC interfaces.
• Fixed the power budgeting issue that occurs when SPOR is disabled.
Release 5.00
• Upgraded an open source component of WS-MAN namely Small Footprint CIM Broker (SFCB)
from 1.3.10 to 1.3.17, where CIM is Common Information Model.
• Fine-tuned memory monitoring daemons.
Important Notes
• While using Remote RACADM client with CMC 5.1 version, make sure that Remote RACADM
client version 8.0.2 is installed.
• When Certificate Validation is Enabled, FQDN of the system must be provided. If IP address of the
Domain Controller is specified when certificate validation is enabled, then the Active Directory
login does not work.
Known Issues
Issue 1:
Description
XWKGY_Intel10G card shows Flex disabled address after racresetcfg of CMC in Network Device Page and
OS.
Resolution
Virtual reseat or Physical reseat of the server.
Versions/Systems Affected
All CMC versions including CMC 5.0 and PowerEdge servers with iDRAC7 or earlier.
Issue 2 (234547):
Description
An error occurs while importing CMC configuration file using local racadm or remote racadm.
Resolution
This issue occurs when IPv6 is enabled or disabled from the configuration file. Enable or disable IPv6
using the command “racadm config -g cfgIPv6LanNetworking -o cfgIPv6Enable 0”.
Versions/Systems Affected
CMC 5.0