Dell Chassis Management Controller Version 5.
Release Notes Dell Chassis Management Controller The Dell Chassis Management Controller (CMC) is a hot-pluggable systems management hardware and software solution designed to provide the following functions for Dell PowerEdge M1000e chassis system: • Remote management capabilities • Power control • Cooling control Version Dell Chassis Management Controller 5.1 Release Date September 2015 Previous Version Dell Chassis Management Controller Version 5.
What is Supported? Supported Web Browsers CMC version 5.1 is supported on the following Web browsers: • Microsoft Internet Explorer 9 • Microsoft Internet Explorer 10 • Microsoft Internet Explorer 11 • Safari version 7.1 • Safari version 8.0 • Mozilla Firefox version 32 • Mozilla Firefox version 33 • Google Chrome version 41 • Google Chrome version 42 What’s New • Firmware and driver refresh of COMMs cards on Dell's 13th generation of PowerEdge servers.
Release 5.02 • Fixed an issue causing CMC redundancy loss in CMC 5.0. • Fixed an issue causing the CMC Web GUI to become unresponsive in CMC 5.0. Release 5.01 • Upgraded OpenSSL to version 1.0.1j. • Updated NTP to version ntp-ssl-4.2.6p3. • Upgraded Apache to version 2.4.10. • Fixed PS-M4110 failure to boot issue in CMC 5.0 • When an IOM is connected through Data Center Bridging, then PS-M4110 must be configured through its own serial port and cannot be configured through CMC interfaces.
Issue 3: Description Flash Media Status showing as "Version mismatch", when changeover the CMC or upgrade the CMC Resolution If chassis profile backup restore is performed on CMC-1 (active CMC) and changeover to CMC-2 (standby) is done, there will be a version mismatch in the chassis configuration profile for extended storage in CMC-2 after the changeover. The mismatch can be prevented by saving any server profile on CMC-1 before changing over to CMC-2.
Installation Instructions For information on installation, see the Dell PowerEdge M1000e Chassis Management Controller Firmware Version 5.1 User's Guide. Upgrade See the Prerequisites section for the correct version numbers. Upgrading Dell PowerEdge M1000e I/O Aggregator I/O Aggregator must first be updated to version 8.3.17.4 before updating to version 9.2.0.0 or greater.
Information in this document is subject to change without notice. © 2014 Dell Inc. All rights reserved. Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden. Trademarks used in this text: Dell(TM), the DELL logo, PowerEdge(TM), PowerVault(TM), Compellent(TM) and OpenManage(TM) are trademarks of Dell Inc. Intel(R) is a registered trademark of Intel Corporation in the U.S. and other countries.
