Reference Guide

• To test LDAP.

racadm testfeature -f LDAP -u joe -p dell123 -d 0xf2

testtrap

Description Tests the RAC’s SNMP trap alerting feature by sending a test trap from CMC to a

specified destination trap listener on the network.

To run this subcommand, you must have the Test Alert permission.

NOTE: Before you run the testtrap subcommand, make sure that the specified

index in the cfgAlerting group is configured properly.

Synopsis

racadm testtrap -i <index>

Input -i <index> — Specifies the index of the trap configuration that must be used for the

test. Valid values are from 1 to 4.

Example

• Send a test trap to the destination configured for index 1:

racadm testtrap -i 1

traceroute

Description Traces network path of the routers as the packets traverse from the system to a

destination IPv4 address.

To run this subcommand, you must have the Administrator privilege.

Synopsis

racadm traceroute <IPv4 address>

Input IPv4 — Specifies IPv4 address.

Output

traceroute to 192.168.0.1 (192.168.0.1), 30 hops max, 40 byte

packets

1 192.168.0.1 (192.168.0.1) 0.801 ms 0.246 ms 0.253 ms

traceroute6

Description Traces the network path of routers as the packets traverse from the system to a

destination IPv6 address.

To run this subcommand, you must have the Administrator privilege.

Synopsis

racadm traceroute6 <IPv6address>

Input <IPv6address> – Specifies IPv6 address.

Output

traceroute to fd01::1 (fd01::1) from fd01::3,

30 hops max, 16 byte packets

1 fd01::1 (fd01::1) 14.324 ms 0.26 ms 0.244 ms