Reference Guide

setsysinfo
Description Sets the name or location of the chassis.
To run this subcommand, you must have the Administrator privilege.
NOTE: The special characters “ (double quotation mark), ‘ (backward quotation
mark), & (ampersand), and \ (backward slash) are not supported for this
subcommand.
Synopsis
racadm setsysinfo -c chassisname|chassislocation <string>
Input
• <string> — Indicates a maximum of 64 nonextended ASCII chassis name or
location.
• -c — Sets the chassis name or location.
Example
• racadm setsysinfo -c chassisname "Dell Rack System"
The chassis name was set successfully
• racadm setsysinfo -c chassislocation chassislocation2
Sets Chassis location.
sshpkauth
Description Enables you to upload and manage up to 4 different SSH public keys for each user. You
can upload a key file or key text, view keys, or delete keys.
This command has three mutually exclusive modes determined by the options —
upload, view, and delete.
To run this subcommand, you must have Configure user privilege.
NOTE:
• For DSA keys greater than 2048, use the following racadm command:
racadm -r 192.168.8.14 -u root -p calvin sshpkauth -i
svcacct -k 1 -p 0xfff -f dsa_2048.pub
• CMC accepts RSA keys up to key strength 4096, but the recommended key
strength is 1024.
Synopsis
• racadm sshpkauth -i svcacct -k <key_index> -p <privilege> -t
<PK_key_text>
• racadm sshpkauth -i svcacct -k <key_index> -p <privilege> -f
<PK_key_text>
• racadm sshpkauth -v -i svcacct -k all|<key_index>
• racadm sshpkauth -d -i svcacct -k all|<key_index>
Input
• -i <user_index> — Index for the user. It must be svcacct for CMC.
• -k [<key_index> | all] — Index to assign the PK key being uploaded. all only
works with the
-v or -d options. <key_index> must be between 1 to 6 or all on
CMC.
• -p <privilege> — Level to give to user for this PK key.
• -r <cmcIpAddr> — Specifies the controller’s remote IP address.
83