Reference Guide

setled

Description Sets the state (blinking or not blinking) of the LED on the specified module.

To blink or unblink the chassis, I/O modules or the CMC, you must have the Debug

Administrator privilege. To enable the servers to blink or unblink, you must have the

Server Administrator or the Debug Administrator privilege.

Synopsis

racadm setled -m <module> -l <ledState>

Input

• -m <module> — Specifies the module whose LED you want to configure.

<module> can be one of the following:

– server–<n>, where n=1–16

– server–<nx>, where n=1–8; x = a, b, c, d (lower case)

– switch–<n>, where n=1–6

– cmc-active

– chassis

• -l <ledState> — Specifies the LED state. The values are:

– 0 — No Blinking

– 1 — Blinking

Example

• racadm setled -m chassis -l 1

Sets LED state on Chassis to Blink

• racadm setled -m server-1 -1 1

LED state was set successfully.

• racadm setled -m server-9 -1 1

ERROR: Server in slot 9 is an extension of the server in slot 1.

NOTE: The setled command generates an error when run on the extension

slot of a multi-slot server.

setniccfg

Description Sets the CMC IP address for static and DHCP modes.

To run this subcommand, you must have the Configure Chassis Administrator privilege.

NOTE: The command helps to modify network configuration properties.

NOTE: The terms NIC and Ethernet management port may be used

interchangeably.

Synopsis

• racadm setniccfg [-m <module>] -d [-6]

• racadm setniccfg [-m <module>] -s <ipAddress> <netmask>

• racadm setniccfg [-m <module>] -s -6 <ipv6Address> <prefixlen>