Reference Guide

• Get Power Status of blade 16 on CMC by using the following command:
racadm serveraction -m server-16 powerstatus
ON
• Turn off the server 16 from CMC, when the power is already turned off on that server
by using the following command:
racadm serveraction -m server-16 powerdown
Server is already powered OFF.
• Power action on all servers by using the following command:
racadm serveraction -a powerup
setarraycfg
Description To configure storage array properties, run this command.
Synopsis
• racadm setarraycfg -m module –n <member_name> <member_ip>
<member_mask> <member_gateway> -e 0|1 -g <groupname> <group_id>
<group_password> [<admin_password>] [-f A|B]
• racadm setarraycfg -f A|B
NOTE: The valid value for -m is server–n, where n=1–16.
Input
• -m — Module is one of the following values:
– server–<n>: where n = 1–7 and 9–15
• <member_name> — A unique and descriptive name that is fewer than 64
alphanumeric characters, without spaces. The first character is a letter or a number. It
is used only to identify and administer the array.
• <member_ip> — Each member IP Network address must have at least one network
interface on the same subnet as the group IP address.
• <member_mask> — Member Netmask combines with the member IP address to
identify the subnet on which the network interface specified resides. The default is
255.255.255.0
• <member_gateway> — Member Gateway network address is for the device that
connects the subnet and forward the network traffic beyond the local network.
• —e — Selects existing or create new group for a member. The valid values are:
– 0 — to create new group
– 1 — to use existing group
NOTE: If —e is 0, then admin password is mandatory.
• <group_name> — Name of the group for administrative purpose. You can use up to
64 alphanumeric characters and hyphens. The first character must be a letter or
number.
• <group_ip> — Group IP and Network address for the group. The group IP address is
used for administrative and host access to volumes.
• <group_password> — Group Membership Management Password is required when
adding members to the group. The password must have 3 to 16 alphanumeric
characters and is case-sensitive.
• <admin_password> — Group Administration Password to set admin password when
creating new group and overrides the factory-set password. grpadmin is the default
grpadmin account. The password must have 3 to 16 alphanumeric characters and is
case-sensitive.
• —f — The valid values are A or B. Select Fabric used for data I/O. Options are:
76