Reference Guide

If you run racresetcfg from a network client (for example, a supported web browser,

Telnet or SSH, or Remote RACADM), use the default IP address. The racresetcfg

subcommand does not reset the cfgDNSRacName object.

To run this subcommand, you must have the Chassis Administrator privilege.

NOTE: Certain firmware processes must be stopped and restarted to complete the

reset to defaults. CMC becomes unresponsive for about 30 seconds while this

operation completes.

NOTE: There is a 100 percent fan request when the command is issued against the

servers.

Synopsis

• racadm racresetcfg

RAC reset operation initiated successfully. It may take several

minutes for the RAC to come online again.

• racadm racresetcfg [-m <module>] [-c <feature>]

Input

• -m <module> — Specifies the device to reset the configuration on <module>.

<module> must be one of the following values:

– chassis — Default state if -m is not specified

– server–<n> — where n=1–16

– server–<nx> — where n=1–8; x=a, b, c, d (lower case)

– kvm

• -c <feature> — Must be one of the following values:

– ad — Reset Active Directory properties to default (default is disabled).

– pcap — Reset Power Cap to default.

– flex — Reset flexaddress properties to default (default is disabled).

– dpse — Reset Dynamic Power Supply Engagement to default (default is

disabled).

NOTE: FlexAddress or FlexAddressPlus will be set to enabled on running racadm

racresetcfg (default is enabled without –c option). The server must be turned

off prior to running this command to change the slot state.

NOTE: -c option is valid with <module = chassis> only.

NOTE: If chassis is the target of racresetcfg, CMC resets after the operation.

Example

• Reset the KVM configuration on CMC.

racadm racresetcfg -m kvm

The configuration has initiated restoration to factory defaults.

• Reset blade 8 configuration from CMC.

racadm racresetcfg -m server-8

The RAC configuration has initiated restoration to factory defaults.

Wait up to a minute for this process to complete before accessing the RAC again.