Reference Guide

For using single quotation marks:

• No character escaping is necessary.

• A single quotation mark is not used even with a backward slash escaped.

NOTE: An empty string may be specified as either ” “(using double quotation marks) or ' '(using

single quotation marks).

racadm ? and ? subcommand

Description Displays all the subcommands you can use with the RACADM command and a one-line

description about each subcommand.

? followed by <subcommand> displays the syntax for the specified command.

To use this subcommand, you must have the CMC Login User privilege.

You can also use the help and help <subcommand> commands to obtain the same

information.

Synopsis

racadm ?

racadm ? <subcommand>

Input

N/A

Output

N/A

Example for RACADM?

The following output example shows the actual output for the RACADM? command. Descriptions shown

in this example may vary slightly from the descriptions in your RACADM session.

racadm ?

help -- list racadm subcommand description

help <subcommand> -- display usage summary for a subcommand

? -- list racadm subcommand description

? <subcommand> -- display usage summary for a subcommand

arp -- display the networking arp table

chassisaction -- execute power-up/down/cycle or reset operation

chassislog -- display the chassislog

closessn -- close a session

clrraclog -- clear the CMC log

clrsel -- clear the System Event Log (SEL)

cmcchangeover -- changes the redundant state of the CMC from active to

standby and vice versa

config -- modify CMC configuration properties

connect -- connect to switch or blade serial console

deploy -- deploy blade or IOM by specifying required properties

feature -- display features active on the chassis / feature

deactivation

featurecard -- feature card status and list the available features

fwupdate -- update the firmware on a CMC, server, IOM inf or KVM

get -- save CMC configuration properties to a file

getactiveerrors -- display CMC active errors

getassettag -- display asset tag

getchassisname -- get the chassisname

getconfig -- display CMC configuration properties