Users Guide

Command Messages
The following table lists the RACADM commands and output for common FlexAddress situations.
Table 34. FlexAddress Commands and Output
Situation Command Output
SD card in the active CMC
module is bound to another
service tag.
$racadm featurecard -s
The feature card inserted
is valid and contains the
following feature(s)
FlexAddress: The feature
card is bound to another
chassis, svctag =
<Service tag Number> SD
card SN = <Valid flex
address serial number>
SD card in the active CMC
module that is bound to the
same service tag.
$racadm featurecard -s
The feature card inserted
is valid and contains the
following feature(s)
FlexAddress: The feature
card is bound to this
chassis
SD card in the active CMC
module that is not bound to any
service tag.
$racadm featurecard -s
The feature card inserted
is valid and contains the
following feature(s)
FlexAddress: The feature
card is not bound to any
chassis
FlexAddress feature not active on
the chassis for any reason (No SD
card inserted/ corrupt SD card/
after feature deactivated /SD card
bound to a different chassis).
$racadm setflexaddr [-f
<fabricName> <slotState>]
$racadm setflexaddr [-i
<slot#> <slotstate>]
ERROR: Flexaddress
feature is not active on
the chassis
Guest user attempts to set
FlexAddress on slots or fabrics.
$racadm setflexaddr [-f
<fabricName> <slotState>]
$racadm setflexaddr [-i
<slot#> <slotstate>]
ERROR: Insufficient user
privileges to perform
operation
Deactivating FlexAddress feature
with chassis powered ON.
$racadm feature -d -c
flexaddress
ERROR: Unable to
deactivate the feature
because the chassis is
powered ON
Guest user tries to deactivate the
feature on the chassis.
$racadm feature -d -c
flexaddress
ERROR: Insufficient user
privileges to perform
operation
188