Users Guide

Setting Description
NOTE: The subnet mask and the gateway
are not incremented like the IP address.
For example, if the starting IP address is
192.168.0.250 and the subnet mask is
255.255.0.0 then the QuickDeploy IP address
for slot 15 is
192.168.0.265. When you try to
set the fields starting IP address, reserved IP
addresses, and subnet mask values such that the
combination may generate an IP address outside
the subnet, the QuickDeploy IP address
range is not fully within QuickDeploy
Subnet
error message is displayed when you
click the Save QuickDeploy Settings or Auto-
Populate Using QuickDeploy Settings. For
example, if the starting IP is 192.168.1.245,
reserved IP addresses is 16 and subnet mask is
255.255.255.0, the IP addresses generated for
slots beyond 11 are all outside the subnet.
Hence, trying to set this combination for
QuickDeploy settings generates an error
message.
iDRAC IPv4 Netmask Specifies the QuickDeploy subnet mask that is
assigned to all newly inserted servers.
iDRAC IPv4 Gateway Specifies the QuickDeploy default gateway that
is assigned to all iDRAC present in the chassis.
Enable iDRAC IPv6 Enables IPv6 addressing for each iDRAC present
in the chassis that is IPv6 capable.
Enable iDRAC IPv6 Autoconfiguration Enables the iDRAC to obtain IPv6 settings
(address and prefix length) from a DHCPv6
server and also enables stateless address auto
configuration. By default, this option is enabled.
iDRAC IPv6 Gateway Specifies the default IPv6 gateway to be assigned
to the iDRACs. The default value is "::".
iDRAC IPv6 Prefix Length Specifies the prefix length to be assigned for the
IPv6 addresses on the iDRAC. The default value
is 64.
3. Click Save QuickDeploy Settings to save the settings. If you have made changes to the iDRAC
network setting, click
Apply iDRAC Network Settings to deploy the settings to the iDRAC.
The QuickDeploy feature only executes when it is enabled, and a server is inserted in the chassis. If
Set iDRAC Root Password on Server Insertion and QuickDeploy Enabled are enabled, the user is
prompted using the LCD interface to allow or not allow the password change. If there are network
configuration settings that differ from the current iDRAC settings, the user is prompted to either
accept or not accept the changes.
111